Power symbols for 12V source and 5V regulator - Schematic - KiCad.info Forums

Right now, I plan to create a PCB shield for an Arduino mega. I plan to have it powered with a 12V LiPo battery connected via screw terminals, which will initially power the DC motors, but I want to include a 5V 2A regulator to control other smaller components. I have the schematic wired up, but when it came to the power source, it got messy. I connected a PWR_FLAG icon to the + and - ends of the screw terminal, and have the DC motor drivers connected directly to the 12V source. Then, I have t

Power and signal - Schematic - KiCad.info Forums

Issue with PWR_FLAG + power regulator - Schematic - KiCad.info Forums

Multiple power supplies when using a logic symbol from the library causes a power net conflict - Schematic - KiCad.info Forums

Is a power flag required in this case - Schematic - KiCad.info Forums

Input Power-Pin not powered by Output-Power Pin - Schematic - KiCad.info Forums

Need help with schematic IC power output pin feeds - Schematic - KiCad.info Forums

Power Ports still causing issues (for me) - Schematic - KiCad.info Forums

Automatically Connected Power Output Pins Creating ERC Error LM1117 Symbol - Schematic - KiCad.info Forums

Can't get power pads!! : r/KiCad

1st schematic - General Electronics - Arduino Forum

Beginner needs Schematic expert review - Community - KiCad.info Forums

How to Design a 12V Input/ 5V,1A Output Power Supply System Schematic in KiCAD Part 1

Question about PowerFlag - Schematic - KiCad.info Forums