Problem connecting 2 arduinos with CAN BUS - Networking, Protocols, and Devices - Arduino Forum

Hi everyone, I started a project where I need to connect 2 Arduino with CAN-BUS protocol. For this I went to the simplest and tried to make ONLY the communication via CAN bus of the 2 Arduino with a simple example I found in the library that you can download directly from Arduino called: "CAN_BUS_Shield-master". As known, there are 2 codes (1 for the transmitter and 1 for the receiver), the transmitter one works just fine (I think). The problem comes in the receiver code, when it checks if data

arduino - RS485 not working - Electrical Engineering Stack Exchange

Connect Multiple I2C Devices to Arduino Using I2C Multiplexer TCA9548A

CAN Bus Messages - Networking, Protocols, and Devices - Arduino Forum

Please Help Arduino CANsendMsg and CANrecieveMsg not working with multiple CAN nodes - Networking, Protocols, and Devices - Arduino Forum

Connect Two Arduino Boards Using I2C Communication Protocol

How to make two Arduino Unos communicate using a CAN bus - Quora

Two Arduinos talking via Bluetooth - Networking, Protocols, and Devices - Arduino Forum

Help - Can Bus Scheme - General Electronics - Arduino Forum

ethernet - How to interconnect multiple Arduinos with a Rpi to control home-lights/switches - Arduino Stack Exchange

i2c Arduino: how to create network, parameters and address scanner – Renzo Mischianti